At the belt
To the widest part
From the stitch of the crotch to the top of the belt, in front
From the stitch of the crotch to the top of the rear belt
From the stitch of the crotch to bottom of jeans
To the widest part
To the widest part
From the top of the belt to bottom of jeans
If you choose the Slim Cut
Take your measurements normally with a tape neither too tight nor too loose for 3A,3D,4,7
Take your measurements much tending the tape measure to 1,2,5,6
Take the width of the bottom 8 of your choice. If you tighten the ankle, add a zip .
If you choose the cut Bootcut
Take your measurements normally with a tape measure or too tight or too loose for 3A,3D,4,7
Take your measurements slightly tending the tape measure to 1,2,5,6
And add 2cm to 6. Take the bottom width 8 you want ( Greater than 22cm )
If you choose the Straight cut
Take your measurements normally with a tape measure or too tight or too loose from 1 to 7
And add 1cm for 6. Take the bottom width 8 you want ( Greater than 18cm)
If you choose the wide cut
Take your measurements normally with a tape measure or too tight or too loose from 1 to 7
And add 4cm for 2,5,6. Take the bottom width 8 you want ( Greater than 27cm )
If you choose the legs Elephant cut
Take your measurements normally with a tape measure or too tight or too loose for 3A,3D,4,7
Take your measurements much tending the tape measure to 1,2,5,6
And add 2cm to 6. Take the bottom width 8 you want ( Greater than 28cm )
You choose to customize without follow our advice
Be very specific about your actions, and complete the scheme of taking measurements from 1 to 8
To take your measurements with a tape measure of dressmaker
Handling the measuring tape is very flexible, depending on the tension you get a gap of 0.5 to 1cm.
Example : Normally 50cm - slightly tending 49.5 cm - much tending 49 cm.
To set the waist height
Low waist , 3D is between 15cm and 22cm minimum maximum.
Normal waist, 3D is between 20cm and 30cm minimum maximum.
High waist, 3D is between 25cm and 100cm maximum minimum.
Generally, 3D should be equal to or less than 3A
To take your measurements, you need to be assisted by a person.
How to take your measurements accurately
You should not wear jeans to adjust the measures taken below :
1 Waist, 2 Hip, 5 Thigh, 6 Knee.
This will allow you to adjust and take accurate measurements.
You must wear a Jeans Slim fit for taking measurements below :
3A Back Rise, 3D Front Rise, 4 Inseam, 7 Outseam, 8 Width at the bottom.
This will allow you to use existing points of stitching on your jeans to define and take action with precision.
Click Download the file and print the.
Take your measurements and refer to the file that you just printed .
To take your measurements, you need to be assisted by a third person.
You can place your order. Click on Create your Jeans.
The measures that you save will be the definitive measures of jeans that will be manufactured.
Choices Overview
